2025HCM Horizontal Spin Trimmer

 
Click to view PDF
Click to View 2025 Spin Trimmer Video

 

Features

Benefits

Heated blade technology Trim virtually any type of resin, including PETG, barrier resins, K resins, PVC, PP, PE; multi layer resins respond especially well.
New redesigned blade holder Allows the blade to nest at the correct angle without a lengthy setup period. Reduced blade changeover time.
New redesigned blade holder adjustment Designed to keep left hand and right hand blades in perfect alignment from the log centerline. Reduces changeove times and provides greater consistency.
Heavy duty 1/3 hp drive with DC variable speed controller Long life and greater consistency in throughput. Allows various line speeds to be run on a single trimmer.
New two pulley drive system with "V" Guide timing belt Allows for better control of containers during the trimming process with no slippage on the drive pulleys.
Simplified belt tensioning Allows for quick changeovers increasing productivity. Reduces chance for operator error during procedure.
PLC controls with panel mounted user interface Reduces setup time and functions as a fault message panel.
Jams and incorrect trim detection Reduces down time and eliminates incorrectly trimmed containers.
Stainless steel infeed chute with bottle metering Proper bottle spacing and positive feed.
Audible alarm and beacon lights for detection devices Faster response time from plant staff. Higher production.
   

 

Features

Dimensions Utility Requirement:
Width 40" Electrical Supply
Length 72" Voltage 120 VAC
Height 89" Amperage 15 AMP
Weight 700 lbs.  

Vertical Compressed Air Supply
Height Line Size 1/4" Pipe
Range 44" ±3"
Height from floor to blade
Pressure 80-100 psi

Motor Ratings: Container Range:

Trimmer Drive Motor 1/3 hp Containers per minute 300 (depending on size)
    Min/Max neck size 1.5" - 7" 25-127 mm
    Min/Max diameter 1"-4" 38-178 mm
Heater Blade Temperature 450°F (Max) Min/Max height 3"-18" 76-450 mm
   
Specifications are subject to change without notice. Guards are supplied and must be in place before operation. All sales are subject to our prevailing terms and conditions of sale. Other options available upon request.

 

 
© 1999-2010 Lectro Engineering Co.      All Rights Reserved.     Use of this site indicates acceptance of the Terms of Use Privacy Policy