5000 Series Container Finishing System

 
Click to view PDF
Click to View the 5000 Series Video

 

Specifications: MTM 5000 Series Trimming System

Trimming System Deflasher Chipless Trim I.D. / Facing Trim
General Purpose of the MTM 5000 Series Trimming System Provide fully finished bottles in either single or dual neck application to customer’s exact specifications Capable of deflashing handle and neck. Will guillotine either single or dual necks Removes a neck ring at a predetermined height for a smooth leak free closure without any chips or bottle contamination Designed to cut neck I.D. opening to a specific diameter and also provide a flat smooth land on the neck surface for a leak free closure
PLC Controls YES Full program and documentation supplied with each system      
Operator interface of Control Functions w/Fault Messaging Color Touch Screen can be moved to various locations while trimmer is running      
Bottle Per Minute Up to 93 bpm* Up to 93 bpm* Up to 93 bpm* Up to 93 bpm*
Bottles Per Index 1 to 8 Depending on size of bottle 1 to 9 Depending on size of bottle 1 to 8 Depending on size of bottle 1 to 8 Depending on size of bottle
Bottle Size Range:
Bottle Diameter min/max
Neck Diameter min/ max
Bottle Height min/max

1.5” – 7” 38 – 178mm
1” – 4” 25 – 127mm
8” – 18 ” 203 – 450mm
Same Neck Diameter min/max
1” – 3 ” 25 – 76 mm
Same

Head Height Adjustment
Servo Controlled to 001"

  YES YES YES
Station Overall Height
Adjustment/Changeover
  Motor driven for quick changeover with overall height adjustment of 6" Motor driven for quick changeover with overall height adjustment of 6" Motor driven for quick changeover with overall height adjustment of 6"
Bottle Infeed Height 36 in. ± 2" Legs Only
Other height available
     
Motion of Stations 14 Servos Clamping motion by servo for quick and accurate nesting with deflashing /guillotining done pneumatically Clamping and height control is done with servo for accurate placement and height adjustment Clamping and height control is done with servo for accurate placement and height adjustment
Tooling Installation   Bolt in with sub plates for quick changeovers Sub plates for neck
inserts pinned in place for quick changeovers
Sub plates for neck
inserts pinned in place for quick changeovers
Frame Design H/D Tubular Steel Same Same and with 8020 substructure Same and with 8020 substructure
Bottle Feed System Provides bottles at correct spacing and accurately places them for proper trim Servo driven screws synchronized with servo driven vacuum conveyor Servo driven walking bean over a stainless steel deadplate Servo driven walking bean over a stainless steel deadplate
Trimmer Guarding Clear sliding doors full length of trimmer Same Same Same
Bottle Feed Conveyor Customer Supplied Customer Supplied Customer Supplied Customer Supplied
Jam Detection YES Sensor and Servo Torque Limiting YES Sensor and Servo Torque Limiting YES Sensor and Servo Torque Limiting YES Sensor and Servo Torque Limiting
Voltage Requirement 480 vac - 60 Hz - 3Ph      
         
* Bottles per minute are only approximate. 93 bpm is with 8 up and less than 9" certificates. Speed is solely dependent on bottle size and shape.

 

 

 

 
© 1999-2010 Lectro Engineering Co.      All Rights Reserved.     Use of this site indicates acceptance of the Terms of Use Privacy Policy