720 Vertical Spin Trimmer

 
Click to view PDF

 

Features

Benefits

Heated blade technology Trim virtually any type of resin, including PETG, barrier resins, K resins, PVC, PP, PE; multi-layer resins responds
Available in either 24" or 30" models Allows versatility for a wide range of neck sizes.
New redesigned blade holder Allows the blade to nest at the correct angle without a lengthy setup period. Reduced blade changeover time.
DC variable speed control Allows various line speeds to be run on a single trimmer.
Heavy duty "A" section drive belt Long life and lower replacement cost.
Heavy duty tubular steel frame Longer life and higher repeatability.
Manual jam release Quick release for clearing jammed containers without the necessity of entering the trim area.
Operator safety Unit shielded by tough PETG safety guards. Safety guards electrically interlocked to shut down the trimmer when opened for operator safety.
   

 

Features

Dimensions Utility Requirement:
Width 30" Electrical Supply
Length 34" Voltage 120 VAC/1 Phase
Height 40" Amperage 8 AMP
Weight 250 lbs.  

Vertical Compressed Air Supply
Height None needed
Range 29" ± 3" Height from floor to blade

Motor Ratings: Container Range:

Trimmer Drive Motor 1/8 hp Containers per minute 60 (depending on size)
  Min/Max neck size 1"-7" 25-127 mm
  Min/Max diameter 1"-4" 38-178 mm
Heater Blade Temperature 450°F (Max) Min/Max height 3"-18" 76-450 mm
   
Specifications are subject to change without notice. Guards are supplied and must be in place before operation. All sales are subject to our prevailing terms and conditions of sale. Other options available upon request.

 

 
© 1999-2010 Lectro Engineering Co.      All Rights Reserved.     Use of this site indicates acceptance of the Terms of Use Privacy Policy