MTM News

Lectro introduces new option for off set neck trimming

Lectro Engineering’s MTM division has designed a plastic bottle trimmer using the design of the popular MTM 742R.   The MTM 732R is a low cost alternative that will allow bottle manufacturers to trim off set neck and wide mouth containers.

The 732 can trim containers at a high rate of speed and maintain orientation on the production line.  It comes equipped with patented heated blade technology allowing the customer to use any resin during manufacturing of their product.   The cost of the unit is a fraction of comparable machines and is unmatched in its ability to change over from one bottle to another quickly and effectively with no tooling change.

The technology is patent pending and seen as a breakthrough for a wide range of stretch blow and extrusion blow molding companies looking to increase market share with new bottle designs.

For more information you can contact us at: Lectro Engineering 1643 Lotsie St. Louis, MO 63132.  By phone at 314-567-3100 or fax at 314-567-3466.








© 1999-2010 Lectro Engineering Co.      All Rights Reserved.     Use of this site indicates acceptance of the Terms of Use Privacy Policy